New Products in Catalog 540

• Ductile Iron Check Valves

• NEW Dickens Pitless Adapters

• Maass™ WT Aluminum Well Caps

• Over-The-Top Aluminum Well Seals

• Tool and Thread Compounds

• New Splice Kits, Connectors, Cable Ties

• Constant Pressure Manifold

• 1/4 Turn Hose Bibb

• Steel Well Seal Air Vent

• 3M Super Tape

• Polypropylene 3 Strand Rope

Dickens Pitless Adapters

S-15 (1") Pitless Adapter

Features:

• Allows greater flow where requireded
• Cast from water well grade 81 Red Brass
• Built-in lowering eyelet for easier installation
• Factory pressure tested to 150 psi
• Water Systems Council listed – PAS-97 (04).
• Large inner and outer rubber gaskets are designed to seal out surface water contamination.

CW-WA Series Pitless Adapters

Features:

• 1” discharge and drop pipe connection allows greater flow where required
• Designed for 4” casing

For complete details on both new Dickens Pitless Adapters, see Catalog 540, page 5.

Return to top of page.

Maass™ WT Aluminum Well Caps

WTCC SERIES

Features:

• WT caps Water Systems Council listed
• PAS-97 (04) listed
• Neoprene gasket to prevent foreign intrusion
• When cap top removed - wire completely exposed for easy service
• Cast aluminum - will not warp or crack
• Stainless steel nuts and bolts
• Downward facing screened vent
• Furnished with rubber grommet to prevent wires from fraying
• Tapped conduit fitting
• 10WTA and 12WTA have 2 - 1" screened vents as standard

Aluminun Well Caps are found on
pages 15-16 of Catalog 540.

Return to top of page.

Features:

• Cast Aluminum Alloy 319 — will not warp or crack
• 3 square head stainless steel cup point set screws
• Seals have 1/2" vent hole as standard
• Machined drop pipe seat with positive Buna-N-Seal

These Well Seals are found on page 27 of Catalog 540.

Return to top of page.

Tool and Thread Compounds

These Tool and Thread Compound products are all found on pages 28-29 of Catalog 540.

TAT WASP and HORNET SPRAY

Features:

• Powerful 20' stream
• Dielectric breakdown voltage
• EPA registered all 50 states
• Kills with residual action

BESTOLIFE™ SuprCopr

Features:

• Lead and zinc free
• High copper content
• Aluminum flakes added, providing sealing characteristics of lead
• Recommended for drill collars, tool joint fishing tools, and tubing
• Provides protection against H2S
• Brushable to 15°F
• Brush top bottles

CAL-BRONZE® - Lead Free

Features:

• Recommended for drill collars, drill pipes, and threading operation
• High temperature formula available
• Special non-metallic additives absorb impact and cushion joints
• Contains copper and graphite
• Will not wash-out under severe conditions
• Galling and seizing resistant

ECO-SIL

Features:

• Excellent thread compound for monitor wells and core sampling
• Non-metallic
• Non-hydrocarbon
• Chemically inert silicone compound

BESTOLIFE™ ZN50

Features:

• Recommended for tool joints, collars and coring joints
• Brushable to 10°F
• 50% powdered metallic zinc
• Contains H2S inhibitors

CoprPlus

Features:

• Ideal for rotary shouldered connections
• No lead or zinc
• Pumpable formula available
• Brushable to -49°F
• Provides lubrication and protection to 400°F

#2 DOPE BRUSH

Features:

• 2" heavy wooden handle
• Plastic hand guard
• Bristles designed for uniform compound applications

PLASTIC PAIL OPENER

Features:

• Lightweight aluminum design
• Opens 1, 2, 3 1/2 and 5 gallon plastic pail
• Equipped with hammer face to re-attach lid

New Splice Kits, Connectors, Cable Ties

UNDERGROUND CABLE SPLICE KIT

Features:

• For direct burial of 14 to 8 gauge multi-conductor feeder cable (copper wire only)
• Easy activation with heat source
• Will accommodate 2 or 3 conductors with ground
• UL and CSA listed

Features:

• Permanently flexible sealant
• Easy activation with heat source
• Splices made using standard wire crimping tool
• 3M material
• Excellent Dielectric strength
• Wide range of sealing capability - will cover a large diameter connection and still effectively seal down to a small diameter cable
• High resistance to moisture, fungus and weathering

Features:

• Quick economical kit for hand tightened waterproof splice
• Includes butt splice connectors, compresion sets, and washers
• Available in two, three and four wire kits
• 3M Company

Features:

• Pre-filled silicone, wire nut connectors
• UL Listed to 486D for use in damp/wet conditions
• Weatherproof™ for interior or exterior locations
• Easy to apply, pre-filled twist-on connectors

• For tying and bundling applications

For additional product information, see pages 33-36 of Catalog 540.

Features:

• Fits 3/4” or 1” male tank fittings
• 0.05% or less lead
• Tapped with (2) 1”, (2) 3/4”, and (1) 1/4” threads
• Inlet and outlet tapped 1” female x 1 1/4” male

Constant Pressure Manifold Package
Consists of:
A. (1) 2 1/2” Stainless Steel Back Mounted Liquid Filled Gauge 0-100#
B. (1) Spring loaded Pressure Relief Valve, set at 100 PSI at factory
C. (1) Steel Mounting Bracket
D. (1) 1” x 1/2” Nylon Bushing for transducer connection
E. (1) 1” x 3/4” Brass Tank Adapter Bushing
F. (1) Chrome Plated Sample Valve or No Lead Brass Hose Bibb

Manifold and Wall Bracket also sold separately.

For additional product information, see page 43 of Catalog 540.

Return to top of page.

Features:

• Cast brass body

For additional product information, see page 51 of Catalog 540.

Return to top of page.

STEEL WELL SEAL AIR VENT

Features:

• Fabricated from 1/2" heavy duty galvanized steel
• Brass and stainless steel 24 mesh screen

3M SUPER 33 + VINYL ELECTRICAL TAPE

Features:

• UL Listed; UL 510 Standard "Insulating Tape"
• PVC tape with high dieletric strength, flame retardant and conformable
• Excellent resistance to abrasion, moisture, alkalis, acid, copper, corrosion, varying weather conditions, and sunlight

POLYPROPYLENE 3 STRAND TWISTED ROPE
Features:

• Yellow
• Spool manufactured from wood or plastic
• 1/4" - 1125 lb. tensile strength
• 3/8" - 2500 lb. tensile strength

These products are all found on page 35 of Catalog 540.

Return to top of page.